Magnetic Tiles Haunted House: Floor/Flat Roof Pieces

Here are the floor and/or flat roof pieces for the magnetic tile haunted house. I designed these to be used with 20x5x2 and 10x5x2 neodymium magnets.  I strongly recommend using these size magnets. If you go larger it may not allow the magnets to rotate within their chambers. 

PLA Filament

Layer height 0.2mm

Infill 15-20%

Neodymium magnets needed: 20x5x2 and 10x5x2.

Magnetic build plate highly recommended but not absolutely necessary.

I recommend brims for the larger pieces (150x75 and 150 x 150) as a precaution to prevent warping on the corners).

For all of these pieces, add a pause print at layer height 6.0mm to insert the magnets. When the print is paused insert the magnets.  I like to alternate these two size magnets between the magnets holes (20x5x2, 10x5x2,20x5x2, 10x5x2, etc.).  I found if I used all 20x5x2 they were too strong and if I used all 10x5x2 it felt a little too weak.

After the magnets are inserted, resume the print. That's it:)

Here is a link to Amazon for the magnets needed for these pieces.

https://www.amazon.com/shop/3dpmom