Under table headphone holder

I wanted to hang my headphones under the controller for my Flexispot. Unfortunately, I did not find what I was looking for on Printables, but discovered this model on Thingiverse. After printing (with a slightly smaller scale) the hanger was still a bit too long for me. Therefore, I have adapted this model a little and also taken my ideal scaling. The space for the headphone band is now about 3cm. The total length are about 9cm and the headphone hangs on 7cm.

I hope you have fun with the model and if it should be a little longer go to the original model on Thingiverse.

Printed without support with 15% infill.

Angepasste Länge und Skalierung