Veloster Gen 2 Center Cap for Turbo style Wheel

This is a two part center cap to replace the stock center wheel caps on a Veloster Gen 2 Turbo style wheel. The main cap should be printed with PETg standing up so that the part will flex without breaking. The outer part can be glued and PLA could be used if desired.

I made this in two parts so that printing would be easier but also so that you could design your own face for the cap if you wanted to. :)

OD is 66mm.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

Yes

Supports:

Notes:

Base cap that goes into the wheel should be printed standing up with supports so that the pegs do not snap when pushing into the wheel. If you print the part flat then it may snap along the layer lines.