Simmons Titan 70 - Rack, Right Arm Pass-Thru Clamp Replacement

This is a replacement for the outer jaw of the passthrough clamp for the right arm of the Simmons Titan 70 electronic drum kit.

updated 02 OCT '23

What changed:

• v1 replaced by v1.1, enlarged diameter of throughholes, increased counterbore depth
• v2 released

v1.1 has a 0.5mm chamfer where edges meet the build plate to help negate elephant's foot, and a 1.0mm fillet inside the counterbores to make it easier to print without supports.

v2 is my personal choice, but it's just an aesthetic switch-up. Whether or not you need to generate supports depends on if your printer can bridge the 46.5mm between posts. I didn't like how my edges looked without supports, so I added 2 thin stripes of tree supports, basically dividing it into 3 short bridge segments. Still manages to use a bit less filament than v1.1, and that's accounting for support material.

I use a 0.6mm nozzle, 0.675mm extrusion width, 0.3mm layer height, 4 perimeters, 3 bottom layers, and 6 top layers.

v1.1 uses ~22.5g of filament and takes me ~35 minutes to print.

v2 uses ~21.5g of filament and takes me ~48 minutes to print.

.STEPs are included for both versions in case anyone needs to mess with 'em.

Cheers!

**Imported from my Thingiverse profile. Dropped old post record on import.

Print Settings

Printer Brand:

Sovol

Printer: 

SV04

Rafts:

Doesn't Matter

Supports: 

Doesn't Matter

Resolution:

0.3mm

Infill: 

15% Rectilinear

Filament: Hatchbox PETG Black

Notes:

I personally use 4 perimeters so my walls come out a little thicker than the stock clamp.

Shameless Plug ==============

Appreciate what I'm doing and want to let me know?

I have a tip jar over at https://ko-fi.com/anvilhobbies, if you're feeling so inclined!
Any contributions are greatly appreciated!

Category: Music