Car Airvent Phone Mount

A quick & easy mount for your phone that rests right within your airvent without any exterior adhesion/mounting needed!
5h 4m
1× print file
0.20 mm
0.40 mm
39.00 g
In the contest Car Holders
11
40
0
643
updated October 4, 2023

Description

PDF

This is a simple mount for your phone that can be printed in under 4-5 hours with minimal supports! It is designed to be as lightweight as possible while still providing the necessary support to hold up your phone. The IRL photos are of an original version that needed to be designed and printed quickly over the weekend without testing… now with more time, the pictured renders are the most up to date version and the model works just as well!

Design:

  • It is currently sized to hold an iPhone 13+; attached is the F3D file with all of the parameters already plugged in, so all that's necessary would be to measure out your phone/airvent(s) and update the height/width accordingly. 
  • The arms in the back slot right into your driver-side airvent; this is currently sized for the “cells” seen in a Chrysler 2015, so of course those values would need to be updated as well. 
  • The sliced-out gap within the lower lip of the part allows for easy plugging/unplugging of charger cables.

Printing Tips:

  • Supports
    • This was designed with the intent of being printed in one complete piece that did not require any assembly, and thus does require supports. If you're confident in your printers' bridging settings, you should have no issues with the interior of the body and should only need supports for the front/back arms. I recommend using Organic supports- default settings work just fine (see the attached print file!), but feel free to update as you prefer.
  • Default print configurations will work well for this, as the part is not overly complex.

Tags



Model origin

The author marked this model as their own original creation.

License