Surprisingly strong when you see the loose tolerances. Managed to keep my door in place behind two car boot struts to swing open my door for the enclosure I'm building.
0.6mm nozzle
PLA
0.3mm later height
Ultra Strong Latch for Drawers or Closets
A ultra strong latch to close drawers or closets with strong power
1,324
2177
23
10 k
updated October 3, 2023
Makes
Comments
Printed in PETG with 30% infill. Used to secure a lid for a second bed.
The soft close latch on our kitchen trash drawer failed due to our twin toddlers abusing it. It was over complicated so I found and printed this as an alternative. It keeps the drawer closed and has a good amount of retention keep ti y hands out of the trash. Printed mine in ABS for longevity and some flexibility.
Closes easily with a strong hold. Ingenious design tbh. Printed in PETG and has lasted a few months, albeit on a door I only use 2-3 times a week.
Worked out perfect for my sliding door, keeping cats out of a room. Appreciate the flexibility of screw lines instead of holes and the easiness of printing.
