Ikea SKADIS + IVAR mount (with heat inserted thread)

I need a way to mount my big SKADIS panel to the IVAR shelves in my shop as I didn't want to drill the walls in my basement. The Original model of this made by @Ulysse_312186 was quite a good fit for me but I didn't like the fact that i needed a nut in back which was hard to reach.

I have redrawn the model in Fusion360 and changed the slot to a hole to fit M5 heat inserts I had lying around.

So this is my version - STL and Fusion360 files attached. Feel free to modify or let me know if you need modifications.

The mount is meant to be used with the original IVAR pins but basically those are standard 6x40mm steel pins. You should be able to get them either from IKEA replacement parts. Otherwise they can also be sourced on Amazon or your local hardware store.

The holes for them are slightly oversized (6.5mm) as the printing process on my end (using a 0,.8mm) squeezed them down a bit. They still fit very tight because of that and I needed to insert them using a hammer which went quite well. Let me know if you face any problems.

Simplified the original model and change from a slot that needs screw + nut to a hole for an M5 heat insert.