Vorn Legacy Tap

8mm rods on Voron Legacy are wobbly. Tap was not ment to be installed on this Voron machine because of bed fixed on springs and flex on gantry. 

IF YOU WAN'T TO TRY IT - IT MIGHT NOT WORK IN YOUR SETUP

I'm using rigid trident bed and it works for me.

Only Tap part needed for reprinting comparing to github is [a]_Tap_Center_V_Legacy.stl. There is no endstop island on it and also belts fixings are gone. Print with regular Voron printing requirements. Heat inserts necessary: - 2 on a front for each part of carriage (where Tap part comes), and 3 on a left part of carriage - where bolts in the carriage goes (as it is in the original. For belts caps use M3x10 BHCS - hole is bended a bit and it is required to use bolt with smaller head. I only tested PCB optical sensor - it fits perfectly with some clearance. You don't need to print [a]_Tap_Belt_Cover_r8_x2.stl from Tap github.

material: ABS, ASA
walls: 4 or more
top/bottom layers: 5
line width: 0,4mm
layer height: 0,2mm
infill: Gyroid 40%

Removed endstop island,
Removed belts fixings