Round Tuning Tower

Simple towers to test your Z axis.

I was having issues with my z-axis skipping and causing prints to fail.

I designed this to help me tune my printer, and to sort out why it kept failing.

I figure someone else might get some use from these.

The walls are very thin, so any variation in the print will be very obvious.  

They should use very little material.

Try them with different settings to see what works for you.

There are Square and Round Towers included.  

The Square tower, depending on how you orient it, can give insights into how the X and Y elements of your printer are working.

I use a 0.4 mm nozzle, if yours is larger it may struggle to make these.

The numbers after “Round” or “Square” refer to how high the tower is above the base measured in millimeters.

Have fun!