Adafruit Feather Case

A case to prevent shorting the bottom pins on an Adafruit Feather while still having access to all the pins. It was designed for the ESP32 feather but will probably work with any feather and maybe most feather wings as well. There's a cutout on the side for the battery connector and another one on the end for the USB connector. There's a small lip to help keep the feather from falling out but I usually also use a glue dot in the middle of the bottom of the feather to make it more secure.

I usually print mine at 0.2mm in PLA and infill doesn't matter because none of it is thick enough to not be all perimeters. With those settings it takes about 45 minutes and uses under 6g of filament on a Ender 3 or a Prusa MK3S.