Mitsubishi Eclipse Seat Back Panel Hook Replacement

I created this model because I took the seat out of a 06 Eclipse from a junkyard to put on my sim rig, and the seat back panel was being held on by a couple pieces of strings. When I took it off, I found that every hook(there's 5) that was supposed to hold the panel to the seat was gone. I designed this out of necessity and I think it turned out very well for my first design. Looking through forums I also found that the hooks break very easily when you are removing the seat back panel.

I designed using not great reference photos so it is not exactly the same, but it is close enough and has been working great for me.

For printing it, I printed it on it's side with supports because when I printed it upright, it was very difficult to get the supports out from bottom flanges. If you are printing more than one, I suggest using the “One at a time” feature in Cura or the equivalent in any other slicer.

If you are having trouble removing or putting back the panel, or having trouble inserting the hooks into the panel, watch this video. It requires quite a bit of force to put the panel back on the seat, so just be aware of that.