Kitchen Clamp plastic springs replacement

Low cost plastic kitchen clamps like the Tescoma, have often the pushing spring that is also in plastic, and always breaks after short time. Those are plastic replacement springs in several measures that may be adapted to different clamps sizes. In this way you will stop to throw out them when break.

They should be printed in PETG or ABS because those materials are more elastic, while on the contrary PLA breaks immediately. 

Print settings:

• Classic mode
• Detect thin wall
• 4 Perimeters
• 100% infill - Rectilinear

Files included:

Several spring sizes in format XS, S, L
L size exists in two slightly different versions, since almost all clamps are not the same and I had to do small adjustments to fit in one of those clamps.