Guitar Hero wall mount (Wii Les Paul)

This is a wall mount that I designed for my Guitar Hero guitars. Designed for the Wii version, but it should fit all Les Paul style Guitar Hero controllers. 

The holes fit the drywall screws I had laying around. I provided a version without holes so you can fit your screws or mount it with command strips. 

Print it in the provided orientation. Strength will be reduced if you print it upright. 
Your normal print settings for strong prints will probably work, it's not a complicated model.

My print settings: 

• 0.2mm layer height
• 5 wall loops
• 6 top/bottom shell layers
• 15% gyroid infill
• Fuzzy skin enabled (0.2mm thickness) (except for the screw holes, using modifiers in Orca)