Stay Fit in the frame

We might stuck in the frame but we should always try to stay fit :)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA Overture Black
• PLA PolyTerra Charcoal Black
• PLA Overture Cement Gray
• PLA+ Sunlu Gray
• PLA Overture Light Gray
• PLA+ Esun Bone White
• PLA Overture White

Swap Instructions:

• Start with Black
• At layer #9 (0.8mm) swap to Charcoal Black
• At layer #10 (0.88mm) swap to Cement Gray
• At layer #12 (1.04mm) swap to Gray
• At layer #18 (1.52mm) swap to Light Gray
• At layer #22 (1.84mm) swap to Bone White
• At layer #28 (2.32mm) swap to White for the rest.