Qubeoid 500

Turn your Qube 500 Into the “Qubeoid-500” robot!

Seriously, I don't know how well this will work as I can't verify the mechanical soundness of them. If you decide to print this, I strongly recommend printing these with 6 or more wall layers and a higher than usual infill for strength. 

The legs should be printable with no supports, but the two pieces will need to be glued together (recommend epoxy or other high-strength glue). I also included an M4 sized hole to the Qube feet to add an internal screw since there will likely be a fair bit of torque on the mounting point.