AeroPress Storage Lid

This is a lid for the classic AeroPress plunger designed for storing coffee or accessories while traveling or camping. The design has clips on three sides that fit firmly over the edge of the plunger, allowing you to store things inside the plunger.

The design also features a flat top, so you can leave the cap on while using the inverted brewing method.

Printing Recommendations

• I printed the model in PLA, though I suspect TPU could yield interesting results too.
• Good layer adhesion is needed to prevent breakage of the clips, so using a layer height that yields the best adhesion on your printer is highly recommended.
• The print should easily clip onto the AeroPress and be removable by gently bending the lid at one clip and placing upward pressure on the clip. If this isn't the case for your print, you may need to scale the print up/down to accommodate shrinkage from your printer.