PV Connector Tool

I created this tool when I was working as a PV/Solar Inspector. The tool can be used to combine the two separate leads.

When inspecting some PV installations I noticed how much time it took to get the measurement leads on and off the different strings of solar panels so after getting my 3D printer I decided I could make my work a bit more efficient.

I've tested the design, printed in PLA on my Ender 3 V2 and it works like a dream, fits all connectors as long as the leads are no bigger than 6mm2. 

It should clamp the connectors in nice and tight.

This is for the side of the tester. For the solar string side I have made some cable combs I will share in a different model page.

Material: PLA

Infill 50%