Voron 2.4 / Trident Canopy Top Hat - REMIX Split model, half printing time & 5g supports
Description
PDFIf you like & use my models please consider supporting my efforts with the button below. Thank you!
…Please be sure to hit like & post a make, I'd love to see your prints!
Add some class to your Voron with this awesome canopy / top hat!
If you have a smaller size printer use these corner models but the original models centre section linked under the description.
It adds a small but needed amount of extra room up top on your 2.4 for your Stealthburner's umbilical cable & Bowden tube enabling you to grab a few extra centimetres of printing height!
I have split the corner model, & added hidden M3 bolt & heat insert holes to attach parts together. I also flattened the backs of the corner & centre parts so they can be printed laying down halving print time for the same full corner parts & only requiring 5g of supports per corner! Bonus!
ADD NEOPIXEL LED'S TO YOUR TOP HAT!!!
https://www.printables.com/model/938251-voron-24-trident-canopy-top-hat-neopixel-led-mod-c
You'll need per corner:
2x Voron BOM M3 heat inserts
6x 8mm M3 Cap head bolts
6x M3 spinning T nuts
You'll need per centre section:
2x 8mm M3 cap head bolts
6x M3 spinning T nuts
2x small length of Voron BOM 2.5mm thick Foam tape - each end to seal panels
Printing:
Print left & right corner parts 1 & 2 twice each per machine.
Lay flat on the backsides as per slicer photo above. Be sure to put some support under the lips of all parts, & behind the Voron logo on the centre part.
Use standard Voron print settings & ABS/ASA.
But what about securing the top plastic panel I hear you say….
Well be sure to print some of these clips! No hardware required!
https://www.printables.com/model/594870-voron-24-trident-top-hat-top-panel-clips-no-hardwa
Want to add a good camera? Try this!
https://www.printables.com/model/594857-voron-24-trident-top-hat-logitech-c920-camera-moun
Please make sure your printer is set up well for this, the tolerances are very tight 0.1-0.2mm! Any less than perfect setup might cause the prints not to fit well or at all!
This is not a reason for a bad review, these models are known to fit perfectly. If you have trouble with the fit please adjust your print settings or seek some assistance with your print profile or mechanical setup.
Model origin
The author remixed this model.
Differences of the remix compared to the original
Split Corner model, added hidden M3 bolt & heat insert holes to attach parts. Also flattened the back of corner & 350 centre parts so they can be printed laying down halving print time & only requiring 5g of supports per corner!
