The X1C Top Light (Over-engineered)

The X1C Top Light (Over-engineered)

 

Glass Top Led Raiser mod + anti glare shield

• BLLEDController compatible
• Fit 12mm ledstrip.
• Fit 15x1mm (10-20mm wide) EVA Foam tape for better isolation between 3dpart and glass top.

Features:

• The top lip is 1mm taller to add isolation foam under the glass top.
• Added smooth anti glare shield
• Hole for the led cable is smaller and smoother with TPU bushing to reduce thermal dissipation.
•  Added few chamfer and fillet for a smoother design
• Deeper light angle (45*d)
• Notch to fit handle screws
   

Print Settings:

• Raiser: 
  • ABS
  • Nozzle: 0.4mm
  • Layer height: 0.2mm
  • PEI plate
  • Speed: 100%
• Anti glare shield:
  • ABS
  • Nozzle: 0.4mm
  • Layer height : 0.08mm
  • PEI plate
  • Speed: 50%

Hardware I use:

• BLLEDController (Light automatically managed by the printer) or any LED strip than is not wider than 12mm.
• EVA Foam tape: Aliexpress or Aliexpress2 (15x1 mm - 5m)

The anti-glare shield is glued or double side taped.

Make sure you print this either with Nylon, ASA or ABS so it can withstand the heat from the ledstrip and from the enclosure.

BENEFITS:

• Fast to print
• Easy to use
• Designed for FDM Printing
• Smooth Operation

• The top lip is 1mm taller to add isolation foam under the glass top.
• Added anti glare shield
• Hole for the led cable is smaller and smoother with TPU bushing to reduce thermal dissipation.
•  Added few chamfer and fillet for a smoother design
• Deeper light angle (45*d)
• Notch to fit handle screws