XTouch (P1Touch) Support and Box

I took the idea of Tack to have the touchscreen mounter in the phone hole, but I wanted it at a similar height of the original screen and also I wanted to hide the cable.

I found that you can power the touchscreen using the supplied connector  so I made a slimmer case with a hole in the back for the cable.

The stand was made on a P1S hole (dunno if the P1P is the same), which have 2 different heights inside for the lock mechanism, that's why the legs are different.
You can press the 2 sides to insert and remove the support, and should have the same hole as the other model.

In the end I found that with precise tolerance the back stands in and you don't need any screw, aniway i already did the screw version so I uploaded both just if someone prefers screws.

I printed it in PLA 0.2mm without any support, I suggest a higher infil for the support to increase stiffness (I did 40%).

The model is completly remade from scratch, i took inspiration for the idea and design.