Pimax Crystal Comfort mod - facial interface spacer

Still somewhat WIP (has some light leak at the moment), but I'm using it as is for the moment.

This does NOT add any space between your eyes and the lenses, other mods exists if you feel your eyes are too close.

This transformed the experience for me from something incomfortable after just a few minutes to something I can wear a long time.

I also added the apache strap and counterweight for good measure, I'm very happy now with the level of comfort wearing the headset

2 version at the moment, I'm using the 3.5mm, but I can see the 4mm beeing better for people with smaller heads than me.

Instructions :

Either print it in TPU as is, or print it in PLA, and before it cools down press it against your headset facial interface to mould it to the correct form.

In the photo, in red is a PLA version, in black a TPU version.

use self adhesive velcro to put it on the headset