Halloween Pumpkin with flatter base and thinner lid

Remix of UserS' Halloween pumpkin to have a flatter base and thinner lid
6
63
0
250
updated September 25, 2023

Description

PDF

I was looking around for a Pumpkin lantern to print for Halloween and really liked UserS' one, but I had to split it into two separate models so it would fit into my 220mm square print area. 

While I had the model in Tinkercad I decided to make a couple of alterations, the first was to shave some layers off the base so it didn't need supports in that area, and to add a 30mm flat internal area to stand a LED tea light.  While I was at it, I also shaved some off the lid as it seemed unnecessarily thick to me, and I figured that would save material and print time.

I printed it using Amazon Basics Neon Orange filament (which is slightly translucent) at 0.2mm layer height.   

Model origin

The author remixed this model.

Differences of the remix compared to the original

Shaved 3mm off the base to make it easier to print and stand better, inserted a flat inside area to put a LED tea light.  Made the lid thinner just to reduce print time and material.  Also split the body and lid into separate models so they would fit on my print bed.

License