"Ender 3 NG - coreXY" to ApolloLander (dual 5015 fans) interface ~ prototype

This was a request by some of my patrons

Printable surface is likely reduced a bit to 200(X)x225(Y)

Has be tested and working!

This replaces the "X CARRIAGE_TOOLHEAD/ENG-XC1_b.stl" piece 
Everything else on the original Ender NG Post HERE

Use heat inserts M3x4mm(L)x4.6mm(OD) or 5mm(OD)
4 on the front and 4 in the back.

The ApolloLander can be found on my patreon (with access to my discord where we can work out any kinks) or patreon shop page (which has a list of supported hotends)

You'd mix the ApolloLander Linear Rails Backplate, with the ApolloLander Wheels Main body

This replaces the "X CARRIAGE_TOOLHEAD/ENG-XC1_b.stl" piece from the Ender 3 NG project (yellow piece in the renders), for a front facing MGN12H mounting pattern (20x20mm), allowing the ApolloLander shroud (dual 5015) to be mounted and possibly other shrouds.

Also a second piece without the relocated endstop for a more generic interface