The flower of life.

It's a print in place mechanism that opens if you rotate the bottom, see animation below!

It's a remix from a Thingiverse model. I twisted the pedals a bit so it would look more like a flower.

I added the baby and the pestle it sits on, these need to be printed separately. There is one pestle with an extruded part that should fit in the flower, but it is hard to print, also it could break. So I printed one with a hole, you can put a steel nail in it. 

I did not do a lot of work in finishing it or testing it my print worked very well, since it was a present for my parents and not something I made for others to print. So if it doesn't print good for you, well at least it was free. 

Also please read instruction on the thingiverse model site, you have to break the rotating part off the bottom part!

 I made a donation link, if I get any donations I will spend some more time in ironing out any issues.

Original license is non-commercial and share-a-like.