QUICK-CLIP : Tick Removal Tool

NOTE: This is an add-on to the pre-existing "QUICK-CLIP : Base Starter Kit"

Post-Processing Difficulty: Easy (Ready to Use from Printer)

Tools Needed: None

Introduction & Instructions:

QUICK-CLIP is a versatile mounting system that I designed for backpack and MOLLE webbing. This is a tick removal tool module that I designed to go with the base starter set (found under my profile). It is attached to and removed from the mounting system in the same way as the other modules.

I printed it with 0.16mm layer lines with PLA with no supports or brims.

Hope you enjoy!