Nordice

@Nordice

Very nice gift for Demon Slayer fans :D

@BenevolentKai_957156

This is a general question, love this print, i just have one issue with every single hueforge I've printed. Plate adhesion. No matter what the sides and corners pop up. I used the round tabs to mitigate it and one side was awful. I clean my plate, have a really good z offset, but still halfway through it pops up. And tape is all I have to try to salvage hours of printing. Any advice? What adhesives has anyone tried? Because i love printing these but it's annoying to have to fight this problem.

28

Celta

@celta

HueForge prints are amazing!

Sieht sehr cool aus.

looks so nice but could not understand how you "swap" to get the extra color with only 1 Ams please >? thanks friend

16

Large Cat

@SaltyCat_1286385

@DougDougi_441451 when you hit print, it will ask you what AMS slot to use for the 5th color(white). I put black in the 1st AMS slot and also chose the 1st slot for white. So while its printing, after black is done, put white in the 1st AMS slot. Hopefully that makes sense (edited)