Demon Slayer - HueForge

It uses 5 colors so make sure you swap one out during the print if you only have 1 AMS.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA+ eSun Black
PLA+ Sunlu red 
PLA+ eSun Yellow
PLA+ Sunlu Grass Green
PLA+ Sunlu White

Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to red
At layer #17 (1.44mm) swap to Yellow
At layer #19 (1.6mm) swap to Grass Green
At layer #20 (1.68mm) swap to White for the rest.