Spray Bottle Holder - Ender 3 V2
Descripción
PDFSlide, slide, slide!!!
Here is a slide-on holder for a 2oz pump spray bottle for your IPA bed cleaning mixture. Just slide the endcap off, slide the holder onto the rail, and slide the endcap back on.
You can find these bottles in most stores in the travel-size section. The inner diameter of the holder is 1.5" and fits the bottle very well with little play. An air hole at the bottom keeps out any suction.
The entire unit is 2" tall.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
Standard - 0.2mm
Infill:
Yes - 20%
Filament: Comgrow PLA Blue
Notes:
Printed on the Ender 3 V2 with a 0.4mm extruder and 0.4mm wall thickness. Check your support settings. Mine ended up pretty solid and were a bit difficult to remove from between the sliders.
Etiquetas
Origen del modelo
El autor ha marcado este modelo como su creación original. Importado de Thingiverse.