Yamaha FZ-07/MT-07 Fender Eliminator Plate

Printed at 20% infill with supports made from Cura at Grid 30% density. Height at .2 turns out nice. Takes about 10 hours at speed 60mm with the included supported model sliced with Cura at 205C tip, 60C bed. Hatchbox PLA.

Best printed vertical tall with supports and the holed tab at the bed. You get some striations in the plate but it looks better than being printed on the side. Then you get very visible layers on the edge.

Post-Printing
I used black plastidip, it matched better with the plastics than semi gloss black. You can still see the layers a bit, but its under the bike. You could buy some filler spray and sand it smooth, then paint it instead.