Hammer Bro. Cosplay Hammer

I broke down the hammer bro. hammer and increased it's size for a cosplay prop. The size was increased to optimally fit on a Prusa Mini. The individual parts can be scaled.

Assembly is pretty basic. Super glue or a similar adhesive will be needed.

1. Print 1ea of each part. Supports should not be needed.
2. Slip the inner ring piece on and it should snap nicely into one of the grooves. Reference the attached photo to see which groove is correct if there is confusion.
3. Do the same for the outer ring.
4. (Optional) Add a few drops of glue to the rings to set them in place. I forgo this because they fit snug enough where I didn't think glue was needed.
5. Glue in the handle top and handle bottom pieces. Orientation is important on these because the ring pieces will get in the way if inserted incorrectly.

Thank you and enjoy the print!

Increased the size and separated the different color materials, so they could be printed individually.