Nozzle floodlight for SOVOL SV06

After the Princore fan mod the view of the Nozzle was free, you could still see nothing, I felt I at least as too dark. The light of the WebCam and the lighting of the pressure chamber did not get there, so something had to happen...

1. I constructed new model

• PETG (because of temp near the nozzle)
• Supports are not needed
• 20% infill 

2. needed parts:

• Option A - 12V LED strips 
  • from eBay, can be splitted every 3cm and are bright enough.
    https://www.ebay.de/itm/384734259156?var=652686821717&mkcid=1&mkrid=707-53477-19255-0&siteid=77&customid=link&campid=5338949369&toolid=20001&mkevt=1
  • 12V Buck Converter to drive the LED Stip
• Option B - 3V Cob LED (tnx to Samuel for the Hint)
  • from ALIExpress
    https://a.aliexpress.com/_mPtBFMI
  • Connected at P7 port of the HotEnd Board
• Cable with the 1,25mm Micro JST connectors 
  https://amzn.to/3ZlCdhp

3. cabling (only Option A)

For the power supply I rewired the free slot (P7) of the hotend board (intended for the unused X-endstop) in the electronics box. So the power supply runs through the 24 pin ribbon cable from the electronics box to the extruder:

• Unplug the connector from the mainboard and connect the two outer wires to 12V from the buck converter.
• cut off a piece of the LED strip (1 part, approx. 3cm, pay attention to the separation points)
• remove the middle wire from the cable with the JST connectors and plug it into J7
  Solder the other side to the LED strip