Sovol SV07 adjustable magnetic probe holder

The original magnetic probe holder for Sovol SV07 and SV07+ printers does not allow the height of the probe to be changed.
I've therefore designed a replacement part that allows this height to be adjusted, so that longer hotend assemblies or nozzle can be used.

For best results, I advise you to print the model in vertical orientation, on the pierced upper side:
- Layer height 0.2mm
- Filling 15% minimum, gyroid

Use the original screws to fix the support to the hotend and add an M3x6 screw to maintain the probe height.

The notch printed on the side allows you to set the height for the original hotend.