ESP8266 Enclosure

I printed the enclosure by jperson(on thingiverse) thinking it would fit my ESP8266/NodeMCU board but it was apparently designed for a different, larger dev board. The holes for the pins fit perfectly though and I liked the form factor a lot, so I adjusted it to fit my board, which just required moving the sides in a little bit.

The board I used is by HiLetGo and measures ~25x48mm.

Print Settings

Printer Brand:

SeeMeCNC

Printer: 

Rostock MAX v3

Rafts:

No

Supports: 

No

Resolution:

200

Infill: 

20

Filament: Overture PLA 
 

Notes:

The bridges in this are short enough that there shouldnt be any need for supports.

Category: Electronics

Version to fit a different NodeMCU board made by HiLetGo that is ~25x48mm.