Pumpkin Cat REMIX - FIXED

If you like my models please consider supporting my efforts with the button below. Thank you!

…Please be sure to hit like & post a make, I'd love to see your prints! (Also be sure to share the love with the original author!)

Here's a little remix of this fantastic model to make it easier to print & assemble.

Print as per the cut models 0.2-0.1mm

Add supports on the lower front paw of the body, underside of the head, & inside the cut pumpkin mask halves.

Slow your print down when you get to the details on the pumpkin mask's face & use smaller adaptive layers on the pumpkin mask to make the layer lines less obvious on the face. Insert Custom G code to slow the print mid way.

Glue parts together.

Please do NOT leave a bad review because you got a bad print or that your supports are hard to remove. That's not cool & is purely down to your machine & print profile settings not the model.

Resized & recut the model so the pumpkin mask is a better fit & added an integrated pin for mounting the head which allows you to angle the head slightly when gluing. I also fixed the floating & unattached ear that causes print failure in the original model.