Wakeboard Snowboard wall mount

If you print a wakeboard hook then the second hook must be mirrored.

There is a difference between snowboard and wakeboard hooks. Wakeboard hooks are 4º inclined to match the curvature of the board.

For booted wakeboard 30 degree hooks, I recommend using a stronger filament. PLA can bend over time, especially if temperatures are high in the room. Wakeboard without boots on PLA 30 degree hooks, I believe it works. Haven't done any serious testing

• Resolution:   0.2 mm
• Wall loops:   5° hook 5-loops       /  30° hook 10-loops  
• Infill:             5° hook 20% /   30° hook ~40%  but more is better
• Material:      PLA ,  PETG
• Supports:    No
• Brim            No

Screw hole

• Diameter :  5.2mm,   0.2 inch

Hole Length :

•  Hook D1  -  28mm,   1.10 inch
• Hook D2  -  25mm,   0.98 inch
• Hook D3  -  15mm,    0.59 inch
• Hook D4  -  13mm,    0.51 inch