Clawth Holder

I wanted a way to quickly and easily grab or put back my micro fiber clothes that I use for cleaning my print beds. This is what I came up with. I call it the Clawth Holder. It's 2 pieces, a base(PLA) and the claw center piece(TPU). Simple push the corner of your rag into the claw and pull your finger out. To remove the cloth, simply just pull it! Can be mounted to the wall with any type of adhesive, I used command strips. I would advise against using velcro as the claw holds the rag pretty good and when removing the cloth, the whole thing will come off the velcro.

Printed the base out of PLA or your choice of non TPU filament. print the center claw piece in TPU. Infill isn't super important but I used 15%.

To assemble, apply super glue to the inside brim of the base and place the claw center piece into place. Hold it for about 30-45 seconds, may want it to sit longer to ensure the glue dries fully.