Yin and Yang holder for Shungite stones

The Yin and the Yang are both printed from the same file. There is a small tab that will align to a small slot. You will need to print it twice in different colors.

Add supports! The tab needs supports. I also used supports in the slot. Print bottom Side down and slice with supports everywhere! I chose .2mm detail and it looks great.

After removing the little bit of supports, you will need to glue the two pieces together. Use a small amount of CA or your favorite 3D printing glue.

Like this design? Then “like” this design! ❤, and if you print it, post your make! ⏫