This is a mount for a filament run out sensor for the Wanhao I3 or Monoprice Duplicator I3 series of printers, I have it mounted on a I3 Plus but it should fit the V2.1 also.
It is made to fit most sensors but I used this one - https://amzn.to/2LsMdRO
Requires two M3 x 18mm screws and matching nuts.
There is also a area inset to allow usage of two sided tape or Velcro pads to help hold it in place on top.
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 Plus
Rafts:No
Supports:
Yes
Resolution:0.125
Infill:
35
Notes:
Print on its side with supports for maximum strength.
Category: 3D PrintingThe author marked this model as their own original creation. Imported from Thingiverse.