Watering Can Spout / Gießkannenaufsatz || HEXAGONS EDITION/INFIL FLAVOUR

Simple watering can spout in case your original one broke. Inner diameter 26,9 mm - fits the common german 10l watering can.

Prints without supports. Use at least PETG so it lasts longer outside. 0,2 mm Layer height is fine enough.

And as everything is better with HEXAGONS  I also designed the HEXAGON EDITION! With a twist! And instead of simple holes there is an Infill pattern you can control directly in PRUSA SLICER to scatter the water 😱😱😱

Go try which infill works best! There are infills that do not work at all, only a few are pretty fine. But the most important question: Does HILBERTCURVE work??? Be the first to prove it!

Still here?
Let me guess, you printed the Hex version with infill, were disappointed and came back to check what went wrong?

Turns out that infill is much more permeable than expected. The infill on the picture is 40% Gyroid which looks pretty dense in the slicer but the water is just running through :(

Maybe we have to use a higher percentage? What about a tiny slot instead of an Infill patern????