Gridfinity 1x2x6 bin for Bambulab P1P complete hotend

The nozzle fits perfect. The magnets snap into the holes. Would Ca e great to add a small gap to the magnet holes, so it's possible to remove the with a screwdriver.

Printed with a 0.6mm nozzle and 0.3mm layer height.

@DanielSchenk_545468 has the model 5 or 6 hight?

Fits perfectly. Great model!

THX

Fits perfectly, only takes 1x2 spaces in the gridfinity grid and nicely presents the hotend.
Also a "Dankeschön" from me ;-)

Prints perfectly, fits perfectly for X1C hotends, takes less room than the 3-base version and is perfectly stackable

I was looking for something like this for quite some time, but I procrastinated designing one myself, so ... DANKE for uploading this. :) (edited)