Bambu Lab Y-Splitter with PC4-M10 pneumatic connectors and 10 x 2.65mm magnets

See Remix notes
7
84
0
648
updated September 17, 2023

Description

PDF

Remixed For two 10mm x 2.65mm round magnets.
Center fillet was not working in Rhino, so I just lofted a surface.

I printed this in PLA with the suggested settings. I had to clean out the X1 side a bit. I'm not sure if it was filament from the support interface, or unsupported housing filament that was a little stringy. I also had to switch from auto to manual supports to eliminate some unneeded interface filament showing up unattached to anything after slicing. 

  • Layer height: 0.08mm
  • Walls: 4
  • Infill: 25%
  • Infill pattern: Grid
  • Enable Support: YES
  • Support Type: Tree (manual)
  • Support Top Z distance: 0.45mm
  • Support/object XY distance: 0.5mm


 

Model origin

The author remixed this model.

Differences of the remix compared to the original

Remixed For two 10mm x 2.65mm round magnets.
Center fillet was not working in Rhino, so I just lofted a surface.

License