Thin and Sleek Raspberry Pi Camera Module Case

Update:

I remixed the case into a Z-Axis camera mount for the Ender 3/Ender 3 Pro. Check it out here:
https://www.printables.com/model/635606-modular-x-axis-raspberry-pi-camera-module-mount-fo

Info:

I wanted a super thin case for my Raspberry Pi Camera so that I could use that to make a webcam mount for my printer but couldn't find any that were sleek or held together well so I made my own! It's confirmed to work with the Module Camera V3 but V1/V2 should work as it mounts the same way but please prove me wrong if I am incorrect. You can even undo the connector without taking it apart by getting a small dull screwdriver or similar as shown in image 3 but please do not pry too hard! When putting it together, you can just hold the nut with your finger. It does not need to be too tight.

I plan to continue to make small changes when I see fit. I'm currently full-time in college so it will be some time. Feel free to modify as you like just please credit when posting. I hope to sometime in the future make a snap together design but I am still learning.

Print settings:

• Infill 100%.
• Layer height of 0.2mm.
• No supports are needed (Flip case by 180 degrees, flat side down).

Requires:

• x4 M2x10 screws.
• x4 M2 nuts.

Changelog:

V1:

• First version.
• + Added vents for the base model.