Arrow Showerhead Holder (handduschhållare för duschkabin)

My showerhead holder cracked which meant the showerhead would fall off unexpectedly while in use. This was not only annoying but bad news for my toes too!

Eventually I got fed up, brought out the calipers, and modelled a replacement in Tinkercad.

This is based on the default showerhead and hose but I've included a link here if you need to make changes to fit a different sized showerhead for example. Simply ungroup, make the needed changes and re-group: https://www.tinkercad.com/things/im1qZLpwQr7

I used the overlapping shapes trick In Tinkercad to try to keep the sides smooth which resulted in a nice final print.

I believe this is compatible with all Arrow shower cubicles and is a drop-in replacement for the broken part.

The final model is printed in Add:North PETG Pro Matte at a 0.15mm layer height and took 1hr 39m to print. The comparison photo which also shows the broken part features a draft made in PLA using a 0.25mm layer height. Both used a 0.4mm nozzle.

I used supports since the base is elevated but these came off easily and in one piece by just prying with a knife.

I know this is a very niche part but I hope it helps someone in a similar position!