WyzeCam-Cover Remix3

Remix of Wyzecam-cover from thing:3364762 (thanks for the original design)
I thickened the roof and added a couple of flat pieces to cover the unneeded small hole in front, and added a drip guard and closed the edge of the USB cord hole (look at the back). Your printer will need to handle some bridging, or you could turn on supports. It should be a bit more weather-resistant than the original.

For indoor out-the-window use I blackened the front-facing areas with a black Sharpie (to greatly reduce / minimize reflections) and printed it in a wood-PLA to make it less obvious next to the wood window frames (IR lights also turned off in Wyze settings). For outdoor/garage use I printed it in white PETG for more UV and water resistance, and to blend into white backgrounds.

The re-design work is available in Tinkercad.

Print Settings

Printer Brand: Creality

Printer: Ender 3

Rafts: No

Supports: Doesn't Matter

Resolution: 0.28

Notes: 

It prints upside down, as saved. If your printer can handle some bridging, you shouldn't need supports, but you can turn them on if needed. I've printed it both ways, depending on filament used.

Category: Camera