[Fusion360 Modular] Tube frame Cable holder

Open this up in Fusion360 and quickly design a version that fits your frame!

Single Part Design, to be printed twice.

Uses a single M3 x 10mm bolt and nut to hold the parts together. Pull the cables through the parts before you screw them together (they'll be locked in).

Values found in parameters:
- DistanceBetweenTubes: Measured perpendicular distance between tubes (standard: 50mm)
- TubeOuterDiameter: Measured size of the tubes you're fixing this to (equal tube size) (standard: 13mm)
- OverlapAngle: Angle to grip the tube, measured from the center of the tube (180 deg max) (standard: 132 deg = 66deg per side)
- RoundedCornerFactor: A decimal number between 0 & 1, directly managing fillets (standard: 0.6)
(go above 1 and I'm not assuring you anymore it'll grip against the tubes)

Example version in STL / STEP / 3MF follows standard sizes.