WOW Cup Lid Leash
The original leash is pretty tough, but eventually fails. This is a replacement lid leash for a toddler's WOW sippy cup.
34m
1× print file
0.15 mm
0.40 mm
Flex
3.00 g
Creality Ender 3 S1 Pro
In the contest Replacement parts
0
6
0
63
updated September 16, 2023
Description
PDF- Print both pieces in TPU (without supports)
- Pay attention to cooling and minimum layer time since the little knob at the end of the strap is taller than everything else and heat can be a problem if you print too fast.
- Thread the strap through the ring
- Thread the small T-shaped end into the ring from the outside. It's a tight fit, but it does fit.
- Add a couple small drops of cyanoacrylate/superglue and seat the strap all the way into the ring (it's a tight fit, but should fit flush on the inside) – be careful not to pull it all the way through!
- This glue isn't strictly needed, but it prevents the strap pulling through with rough handling.
- Trim the broken leash/strap off of the original lid and clean up the edges
- Drill a 4mm or 5/16" hole in the center of the lid
- Snap the new leash nub into the new hole (it's also a tight fit, but that's what we want!)
- Unscrew the top of the cup, remove the old/broken ring, and add your fresh new one in its place!
Tags
Model origin
The author marked this model as their own original creation.
