3D Printed Half Dart Pusher for the Nerf Regulator & Hyperfire

FIANALLY! A half dart adapter for the Nerf Regulator and Hyperfire! I designed this myself as an option to make the regulator a bit more usable, since the stock pusher mechanism will only fire full length darts! To use this all you need is this pusher, which is 3 3D printed parts, some pieces from the stock pusher housing, and a single 2mm x 20mm dowel pin, an upgraded flywheel cage, since the stock cage has smaller diameter wheels that will not feed half darts very well even with this pusher installed, and a compatible magwell adapter! I personally have only tested the Worker “Springer” adapter, and the OFP adapter. Both of these put the mag in the right spot. Because the Regulator has a small sensor to detect how many darts have been fired, the mag's feed lips have to be just behind it with the dart heads sticking out right in between the sensors. For the Hyperfire any magwell adapter should work fine, but I haven't tested this with that blaster yet. I will work on making full assembly instructions, but for the time being this is pretty simple to build, so I won't try to explain it in this description. If you know what you're doing, then it shouldn't be a problem! I would personally also recommend replacing the Regulator's stock board with the “Goshfun” board from Amazon, since that's what I use, and it adds some awesome features and allows you to run the blaster with select fire on a 2S or 3S lipo. Feel free to message me if you have any questions!

Updated to version 2. The belt required a bit more clearance for smooth operation. Link Gear is still the same. 

Update to version 3

Fixed front post position to increase belt tension. 

Fixed one tooth on the pusher gear that cut cut off in Fusion