AMS Safety Stopper For Bambu Lab X1C Ventilation Frame

I installed my remixed version of Marwyn's ventilation frame for the Bambu Lab X1C.

I also installed the tool storage I remixed here: https://www.printables.com/model/573865-bambu-lab-carbon-x1c-with-ams-top-half-tool-storag

The issue I ran into was with the tool storage on top, the AMS sat very close to the rear edge of the printer. I designed and printed up a bracket that attaches to the ventilation frame. The bracket adds an additional 2mm, so if your screws aren't long enough, buy screws that are 2mm longer than your originals.

Works perfectly and now my AMS isn't going anywhere. I recommend this stopper bracket even if you aren't using the tool storage.

Print with supports.

Not necessarily a remix, but an additional part for the original.