Garden Water Hose Clip Holder

I needed to get my garden hose off of the ground so that the lawn mower/edger/weed whacker would not damage it.

Also, I wanted it to use the weight of the hose to hold it down in the clip.

I printed this using PETG with a 0.2 layer height and 15% gyroid infill.

It holds the hose nice and tight, yet it is easy to move it out of the clip if needed.

The inner diameter of the clip is 20mm.  You can scale up or down if you have a different sized hose.

I used 3/16 x 1-¼" Masonry Screw Anchors to mount these on the brick wall.