Prusament Modular Multispool for Samples and Filament Ends

Don't you hate it when you have those small last amounts sitting on a spool taking up a bunch of space? Use this! It is a multispool made using leftover prusament spools to hold the last~300g or less of filament.

The item is modular if you want slightly smaller than standard spool width you can print one spacer and one edge. That would result in one spool holding 2 filaments. However, you could print however many spacers as you want to make the thickest spool out there.

Post-Printing

How to Assemble

Assemble with m4 screws and m4 nuts.

In hole positions Set A screw through the counterbore holes in the Spacer/Edge part and secure with 4 m4 nuts.

In hole positions B screw through the prusament spools in these hole locations into the tapped section of the Spacer part.

Post Processing

Remove the built in counterbore supports.

Print Settings

print flat on build plate no supports.

Category: 3D Printer Accessories